Both the Silver3 and Gold3 use a four piece OTL cantilever with a Grado specific elliptical diamond stylus mounted on a brass bushing. With the Silver3 and Gold3, a machined turned generator is used to achieve a lower distortion and greater transparency. The Gold3 are hand selected from Silver3 production runs which meet higher test specifications. Approximately 5% of the run usually exhibits these specs and become a Gold3.
- Frequency Response: 10-60 khz
- Principal: MI
- Channel Separation at 1KHz: 35
- Input Load: 47 kohms
- Output at 1KHz 5CM/sec.: 5mV
- Recommended Tracking Force: 1.5 grams
- Stylus Type: E
- Inductance: 45mH
- Resistance: 475 ohms
- Compliance CUs: 20
- Stylus Replacement: U
- Mounting: S/P
- Weight: 5.5 grams
